Creality Halot One Resin Tip

I found via the Creality Facebook group a useful tip: If you have a monochrome lcd such as the Halot One - start by cutting the recommended exposure time on the bottle in half.

For example - Elegoo Water Washable Resin, Grey the bottle says 60 seconds bottom layer exposure and 8 seconds layer exposure. For the Halot One, cut this to 30/4 and start your test print there. I see a little bit of over exposure but the initial results were still really good.

The test print I'm using can be found here: https://www.thingiverse.com/thing:4707289